Sunday, December 26, 2010

Epic Storm ?

Well, that's what the news is calling it. Started to snow Christmas day about 2 pm and ended today about 5 pm. While it is a lot of snow for us, it is supposed to go above freezing tomorrow and approach 60 degrees by Saturday. I went out this evening to check on outdoor kitty's and to clean off the car. I would say 10 inches with drifting to 12-14 inches. The roads are covered with packed snow and are passable. Here are a few shots.




It was a great day to curl up with a good friend and watch football, the Redskins even won for a change. The Cub is on hold till it warms up a little.   

Tuesday, December 21, 2010

Throttle Question

OK , I need help with this one. I have lots of pictures to help put the Cub back together but none of this area. I need to know how the throttle cable is attached to the side of the fuselage just behind the instrument panel. Here is a shot of mine.
The back of the instrument panel is at the left, the black tube is the cross member at the lower edge of the panel. The small silver/rusty tube in the middle is the throttle casing clamped to a welded boss on the fuselage longeron.
After leaving this clamp , mine runs over this diagonal tube then down to the hole in the firewall. I am wondering if there is a special clamp that is longer and allows the control cable to run under this tube instead of over. Of course the Piper parts manual pictures don't show this installation, and the clamp does not have a Piper part number. I would like to make sure this is correct before I install the instruments and it might still be possible to correct. Here are a couple more shots of the same area.

I finished the pitot and static system today, however the batteries died in the camera so no pictures. I hope to finish the magneto wiring tomorrow.

Monday, December 20, 2010

Fuel system complete

Wow, progress has really slowed. With the holidays and some home projects, I'm only getting a couple hours a day on the Cub. Today I finished the right side of the panel and the fuel system. Yesterday I finished making the hoses for the fuel system. I had some problems initially , I think just because the hose was so cold. I could not get the fittings to go on without the tool slipping right near the end . I finally took the hose in the house and heated it in the oven at 100 degrees and everything went smooth. The fuel has been on for a couple days now with no leaks noted. Here is a shot under the tank.
  Here is a shot under the panel showing the installation of the primer, oil temperature and oil pressure lines. It is a real back breaker working up under here, so I took special care to hopefully make this maintenance free for years.
Here is a shot on the engine side of the firewall, I will probably seal all the holes with fireproof putty after everything is complete.
And here is the gascolator and the fuel line to the carburetor.
Last but not least, we have the right side of the panel with the gauges installed for an extended trial fitting.
I'm still looking for the "solo rear seat only " placard, not sure there was one with the project. It goes where the two small holes are at the lower right. I will install a slip / skid ball after the airplane is assembled and leveled. The temp is supposed to moderate this week, so I may get the panel finished and start on the cowl.