Friday, May 6, 2011

Controls

Not really much visible progress today. The UPS man brought my Univair parts which included the aileron links. After lunch I went out and installed them. These are a substitute for the AN115 shackles that I could not bend to fit. These will work just fine.

With these finished I installed the bushings I made yesterday, I had some drilled bolts close but just one size too long! The long bushings keep the aileron cables off the wing strut.

I then spent the next couple hours trying to get the aileron rigging and control feel to suit me. I am going to have to make a short link to go in the balance cable joint otherwise a couple threads show on the lower turnbuckles. I think that will be less work than replacing a cable.
  I then spent some time checking the aileron and elevator control travels and checking them against the TCDS. I have them all within 2 degrees , which will be good for starters and I will fine tune them after it's flying. With all the bends in the wing ribs, the rigging was a series of compromises anyway. Check out the the aileron well root rib on the left side !
It bends up about 3/4 inch where they got the fabric too tight. The right side is straight.  It will take flight rigging to make all the subtle bends cancel out ! I installed some cotter pins and finished a few more details before the rain moved in and I had to knock off.

Thursday, May 5, 2011

Lathe Work

Finally got back on the Cub today, after taking a few days off. The local FBO has this sweet little Atlas Lathe and they let me use it . The sad thing is , I think I'm the only one that does use it. The boys in the shop were jamming some metal music, so I just pretended I was the Moultrie manic mechanic and actually knew what I was doing, NOT.

http://www.youtube.com/watch?v=cEwPL0ogjLw


  I needed to cut off the starter pinion shaft for the engine and make two 1 inch bushings for the front strut aileron pulley bracket. I decided to cut the pinion shaft for the Skytec starter installation. I do not see how this could be done after engine assembly without contamination of the oil system. This will limit this engine to only the Skytec lightweight starter but that is not a bad thing . I used a simple parting tool for this cut.
I had bought a couple of these off of Ebay in poor condition so I did not have to ruin a good one. I made two, the first one was for practice but came out just fine.
I then made the two bushings from some 3/4 aluminum round stock I had. I parted off two pieces, then faced them off to length. I then bored the 5/16 hole. They came out pretty nice.
  Here they are all finished up.
After this was finished I used their Chinese 3 in one tool to shear and bend the new wing root fairings. I made these from some 0.025 6061-T4 stock I had . They just fit on the 36 inch machine. They came out much better than I could have done with snips and 2 by 4's. They still need final trimming.
Tomorrow will be all wing root fairings, check back for progress.

Wednesday, May 4, 2011

Form fitted Trojan

If you remember a while back I had a cover made for the Trojan by Kennon Covers. I was not unhappy with the cover, I just thought it could fit a little better around the windshield. You can see the excess material in this shot. I talked this over with Joe at Kennon and we came up with a plan.
I made some paper patterns of the windshield and forward glare shield area and sent them back to Kennon with the cover.
 
They modified the cover and it came back Saturday. I went down to Wakefield today and got the airplane to try it out. I think it came out really nice. If it still looks a little puffy it's because the wind was blowing about 20 knots and lifting it a little.




Just been finishing some details on the Cub, update tomorrow.